Level III Installer

Apply Now

Overview:

Install or repair cabling and infrastructure used in telecom systems.

Department:

Operations

Position Type:

Non-Exempt

Reports To:

Director of Operations

Travel:

Essential Functions:

Perform advanced work operations in accordance with customer’s instructions for the installation of exchanges
Perform installation planning
Install, maintain, and repair telecom distribution and transmission systems, including superstructure, network equipment, conduits, industrial batteries, DC power and signal cables, cable rack and fiber guide systems and related equipment
Submit redline drawings and all required project documentation on time
Able to read and understand simple mechanical, electrical, engineering and instructional documentation
Adhere to safety practices and procedures
Drive vehicles equipped with tools and materials to job sites
Travel to customer’s facility
Work on energized low voltage DC circuits

Required Skills:

All activities are subject to repetitive and extensive labor. Extended hours may be required by the customer. Work assignments take place in various facilities and environments both in and outside of the Customer facilities, including but not limited to stairs and rooftops.

Ability to travel between destinations via employers preferred mode of transportation to include rental vehicles and flying.
Able to read and fully comprehend blueprints/floor plans
Able to read and write simple mechanical, electrical, engineering, and instructional documentation
Possess leadership skills, be able to train and convey instructions to subordinate employees
Able to ascend and descend ladders repeatedly and work in elevated spaces up to 20’
Able to regularly lift up to 50 pounds and transport up to 100 yards while safely maneuvering equipment and materials
Able to work on feet for entire shift
Ability to competently use basic hand and electric tools (Telecommunication Industry Standards)
Able to repeatedly pull large DC power cabling overhead and in confined spaces
Know standard Telco color code
Use DMM & Amp Clamp proficiently
Know basic electrical theory
The ability to listen to and understand information and ideas presented through spoken words and sentences
Excellent troubleshooting and critical thinking skills. Ability to use logic and reasoning to determine the cause of operating errors and suggest solutions for resolution
Complete all applicable reports and required project documentation on a daily basis and submit electronically
Able to follow established procedures to complete required tasks
Maintain good housekeeping practices
Possess good interpersonal skills and ability to work in a team environment
Strong working knowledge of MS Office (Outlook, Excel, Word)
Ability to effectively communicate both verbally and in writing
Ability to take direction and to work on projects with minimal supervision

Education & Experience:

Completed certification training and testing to labor grade
High School Diploma or Post-Secondary Certificate, preferred
Verifiable experience in the telecom field as an installer, min. 3 years
Valid Driver’s License
Pass a physical examination
Negative drug screen
RF Awareness Training
OSHA 10/30

Personal Tools Required:

Scissors	Power Knife
Lacing Needle	Tool Box / Tool Bag
Flashlight	Sharpie
Tape Measure	Flush Cutters
Hammer	Cable Cutters (Bone Cutters, Lobster Claws
Socket Set	Nut Drivers
Needle Nose	Cable Ringer For Cat5/6
Socket Set	Set Tools (for anchors)
Vice Grips	Channel Locks
Work Boots (non-slip soles)	Rj45 Crimper
Camera	P-Touch
Tin Snips	Unwrap Tool
Spudger	Smart Phone w/5 Megapixel Camera or Better
Cordless Drill	Drill Bits
Socket Set	Drill Bits
PPE	Heat Gun
Rj45 Tester	Laptop w/ Current Software To Run Outlook, Word and Excel